Map in PCM+ 2.3

[Paulen]

Have two nodes that PCM never have been able to map correctly, see attachment.

Anyone experienced this?

Also I have several non-HP nodes that use the same SNMP communities, and thus pops up in node manager. I am able to exclude all but one. For this one PCM just hangs when trying to exclude it. I think I removed it from PCM+ 2.2, but after upgrading to 2.3 it's still there..

[Paulen]

Just to clarify - the switch in the middle is a 5304xl running E.10.67. This is the same switch that shows up as a blue square (identical ports on each side).

From the 5304xl it clearly states that:

h05grens1> sho cdp nei det

CDP neighbors information

No records found

h05grens1> sho lldp info rem b2

LLDP Remote Device Information Detail

Local Port : B2
ChassisType : mac-address
ChassisId : 00 30 6e ad a4 00
PortType : local
PortId : 26
SysName : h05renasps1
System Descr : ProCurve J4900A Switch 2626, revision H.10.29, ROM H.08.0...
PortDescr : 26

System Capabilities Supported : bridge, router
System Capabilities Enabled : bridge

Remote Management Address
Type : ipv4
Address : 10.20.15.26


h05grens1> sho lldp info rem b1

LLDP Remote Device Information Detail

Local Port : B1
ChassisType : mac-address
ChassisId : 00 0f 20 16 e3 c0
PortType : local
PortId : 25
SysName : h05renas1
System Descr : ProCurve J4900A Switch 2626, revision H.10.38, ROM H.08.0...
PortDescr : 25

System Capabilities Supported : bridge, router
System Capabilities Enabled : bridge

Remote Management Address
Type : ipv4
Address : 10.20.15.11

[Evert Goor]

had the same with a link between 2 5400 switches. Upgrading failed. I reinstalled the complete pcm. Means complete dinstallation and then the problem resolved. Only problem is that you have to revoke your old license and relicense your pcm again