Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Mass deployment of SSH? SNMPv3?

Preston Gallwas
Valued Contributor

Mass deployment of SSH? SNMPv3?

I was looking to switch all TELNET connections to SSH for PCM in an effort to boost network security. Is there a way to mass-configure SSH? What are the 'gotchas'? Is there anything I should know about limitations of using SSH only?

Likewise, I'd also like to implement SNMPv3. Same questions as above. Your help is appreciated in these matters
3 REPLIES
Kell van Daal
Respected Contributor

Re: Mass deployment of SSH? SNMPv3?

Hi Preston,

an easy way to do this is to use the "CLI" feature in PCM.
Just select all the switches you like to adjust, and click on the CLI button.

There you can input commando's that will be executed on the the selected switches.
Something like:

crypto key generate ssh
ip ssh
etc...

Then deploy these commands to the selected switches (can also be scheduled).
After this, check if ssh and snmpv3 works for all switches.
If it does, you can use the CLI feature again to remove the normal telnet and snmpv2 if wanted.
Preston Gallwas
Valued Contributor

Re: Mass deployment of SSH? SNMPv3?

Thanks -- they're all procurve 2600 series running 8.53 firmware..so it should be fine.

Theres no confirmatino to the cert generation?

I guess I'm just not familiar with what commands need to be set for a full-implementation for SNMPv3 either then

thanks for the reply!
COS_3
Occasional Advisor

Re: Mass deployment of SSH? SNMPv3?

Does anyone know if 2500 series, 4000m and 8000m supports SSH ?