Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Mesh between 4000m and 5304

HERMANN,OLIVER
Occasional Visitor

Mesh between 4000m and 5304

Hi,
I want create a mesh domain between two 5304 and one 4000m switch. Meshing between both 5304 switches work perfect but the meshing between the two 5304 and the 4000m doesn't work (Not Established)
Spanning Tree (STP is on all Switches enabled
Firmware 4000m: C.09.22
Firmware 5504: E.08.42
Thanks
Oliver
1 REPLY
HERMANN,OLIVER
Occasional Visitor

Re: Mesh between 4000m and 5304

I found the solution,
I have only active the backward compatible mode on both 5304 switches, so they can work with 4000m (older) switches
CLI:mesh backward-compat

best regards
Oliver