HPE Community
Switches, Hubs, and Modems
1751885 Members
5612 Online
108783 Solutions
New Discussion

Meshing with 5308 and 5406

 
Vincent Liu
Occasional Contributor

‎03-26-2007 04:04 PM

‎03-26-2007 04:04 PM

Meshing with 5308 and 5406

We have an existing four-5308 mesh running. We need to add one more switch to the mesh because of expansion. Can we add an 5406 or 5412? Or should I stick with 5308?
0 Kudos
1 REPLY 1
Mohieddin Kharnoub
Honored Contributor

‎03-28-2007 07:02 AM

‎03-28-2007 07:02 AM

Re: Meshing with 5308 and 5406

Hi

The ProCurve 5400 supports Meshing, and it shouldn't be a problem at all.

Anyway i prefer you check the following link for some ideas and notes on meshing examples:
ftp://ftp.hp.com/pub/networking/software/3500-5400-6200-ATG-0207-K_12_XX-05-Mesh.pdf

Good Luck !!!
Science for Everyone
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.