Need assistance with a HP J3202A Switching Hub

[Mandy Webb]

I have a HP J3202A with no manuals and no information. It was previously configured in a network, but I have no idea what the IP address was. My experience and knowledge with this equipment is limited and the human resources available to me are limited as well. I need to know how to determine what the IP address was on this unit so that I can change it to work in my network...OR how to reset the unit to factory default and configure it as a new unit into my network. Can anyone assist me??

Thanks,
Mandy

[Carlos D Echevarria · Accepted solution]

Those switches have a segment display button. If it is pressed for more than 8 seconds the pasword is cleared.

This link can help with the documentation

http://www.hp.com/rnd/support/manuals/hub_12r_24r_24t.htm

[Mandy Webb]

Since my unit does not have the module with the reset button, does that mean that it is not able to be configured? How do I determine if it has an IP address? Must I purchase this module?

[SCOOTER]

Hi Mandy,

You need the J3210A Management Module to configure the switch and since you state that you have none there can be no IP on the switch.

Regards,

SCOOTER