Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

No boot poosible after software update on the 2610-48

Sosin
Occasional Contributor

No boot poosible after software update on the 2610-48

Hallo,
I tried to update image through xmodem for procurve 2610. from 11.30 to 11.54.
After I rebooted switch I could see software inizialization is done. But I couldn´t see login screen anymore. I tried to recover image trough "reset and clear". I could upload image again but again couldn´t login.
1 REPLY
bolli
Frequent Advisor

Re: No boot poosible after software update on the 2610-48

Hello

have you try to change the baud rate?
If this does not work try the factory default reset:
press and hold the clear botton, press and hold the reset botton,
release the reset botton and continue hold the clear botton,
when the sel test LED begins to flash release the clear botton.

Now you can connect the switch via serial connection.
For the Future try updates vie TFTP. It is faster and you are more save the Firmware is send correctly.

Regards