Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

PCMPlus Logs Filling With Warnings

sharrison72
Occasional Contributor

PCMPlus Logs Filling With Warnings

I have issue with PCMPlus event logs filling up with trap messages "snmp: SNMP Security access violation from (ip address of PCMPlus server)." However, if I use the PCMPlus utility to "Test Communication Parameters in PCM" everything reports good. I'm using SNMPv3. I've verified that the PCMPlus server is allowed to access the switches. This is a relatively new occurence, can't tie it to an event, but possibly upgrading PCMPlus to 3.20.1741? I know that I can turn off the logging of these traps, but I'd rather keep an eye on those kind of things. Any ideas on how to fix either PCMPlus or the switches so that they don't see valid requests as security violations?
3 REPLIES
Tore Valberg
Trusted Contributor

Re: PCMPlus Logs Filling With Warnings

Hi

what switch and what software version is the switch running?

We might have a fix for you

Tore, Support
sharrison72
Occasional Contributor

Re: PCMPlus Logs Filling With Warnings

5 switches are responsible for probably 98% of the messages. They are:

1 - 2626C ROM H.08.05 SW H.10.83
1 - 2626B ROM H.08.02 SW H.10.83
2 - 2650B ROM H.08.02 SW H.10.83
1 - 2610-24-PWR ROM R.10.06 SW R.11.63
Tore Valberg
Trusted Contributor

Re: PCMPlus Logs Filling With Warnings

Hmm

I haven't heard of any issue like that on those platforms.

I tried to set up a quick test, but seem to be fine here,

Are you sure there are no other SNMP application running on the same server querying those switches?

If no, i think i will advise you to log a case with support.
Tore