HPE Community
Switches, Hubs, and Modems
1753935 Members
9685 Online
108810 Solutions
New Discussion

Re: Pro-curve 1410-8G - No link

 
gui_calabria
Occasional Visitor

‎11-01-2011 03:30 AM

‎11-01-2011 03:30 AM

Pro-curve 1410-8G - No link

Hi,

 

   I have the  Pro-curve 1410-8G, J9559A but it's not working.

   After turned on, the power led looks Ok(green), we connect the cables but any led's link have turned on.

   I already connect computers and hubs, no matter what no link appears, like when it's disconnected.

   What should I missing?

 

Regards,

Guilherme

0 Kudos
2 REPLIES 2
gui_calabria
Occasional Visitor

‎11-01-2011 10:21 AM

‎11-01-2011 10:21 AM

Re: Pro-curve 1410-8G - No link

Just making a correction:

when we connect the cable the leds DOESN'T have turned on.

The computer shows unpluged...

???

0 Kudos
SCOOTER
Esteemed Contributor

‎11-02-2011 08:57 AM

‎11-02-2011 08:57 AM

Re: Pro-curve 1410-8G - No link

If you also have tested another cable and/or made sure the cable you use is good there is nothing much more to check. The Link/Act led is either "off" (no link),  "on" (link) or  "flashing" (activity) and the Speed led "off" (10/100 Mbps) or "on" (1000Mbps).

 

I just checked one of mine and the Link led is flashing and the Speed led is off and that is correct since it's conneted to a 10/100 NIC.

 

When you un- and re-plug the power, do all LEDs light up as they should or only the power led?

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.