ProCurve Switch 2510G-24 and SNMP

[Hajo Kumschlies]

fine, now I have 3 snmp servers...

[Hajo Kumschlies]

how can I delete a snmp server in the config?

[Jan-Philipp Warmers]

no snmp-server host all

[Hajo Kumschlies]

sorry, doesn´t work

[DSV12]

Syntax: [no] snmp-server community < community-name >

eg no snmp-server community public

Look at http://cdn.procurve.com/training/Manuals/2510G-MgmtCfg-Jun2008-59923095.pdf p.12-17

[Hajo Kumschlies]

Sorry, this link doesn´t work...

[Hajo Kumschlies]

SWGE122(config)# no snmp-server community public
SNMP community not found: public.
SWGE122(config)# show snmp-server

SNMP Communities

Community Name MIB View Write Access
---------------- -------- ------------

Trap Receivers

Link-Change Traps Enabled on Ports [All] : All

Send Authentication Traps [No] : No

Address Community Events Sent Notify Type Retry Timeout
--------------------- --------------- ----------- ----------- ----- -------
10.25.10.34 public All trap 3 15
10.25.10.34 /16 All trap 3 15
10.10.10.10 public All trap 3 15



Snmp Response Pdu Source-IP Information

Selection Policy : rfc1517

Trap Pdu Source-IP Information

Selection Policy : rfc1517

[Jan-Philipp Warmers]

Hi

now i checkt

no snmp-server host 10.10.10.10 public

works for me

[Hajo Kumschlies]

Hi,

this was beautiful, it worked!

How can I send a test trap?

[DSV12]

> Sorry, this link doesnà ´t work...

Fantastic. Even yesterday, the link worked, I checked. Here is actual (at now) link:

http://ftp.hp.com/pub/networking/software/2810-MgmtCfg-July2007-59914732.pdf