Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem Tagging between Switch Procurve_1700-24 and AP Cisco_1240

Djuma Cauwenbergh
Occasional Visitor

Problem Tagging between Switch Procurve_1700-24 and AP Cisco_1240

Hi all,

I connected a Cisco Access-point to a HP_Procurve_1700-24.
Port Fa 0 on the AP is a trunk (vlan 1 & 2) and vlan 1 is untagged (native).
Port 23 Procurve 1700-24 (where is the cisco connected) has both vlans (1 & 2) - Traffic = ALL and PVID = 1.
There is no traffic on vlan 2 between 1st laptop connected on 1700-24_Port 24 with Traffic = Tagged only - vlan 2 and the second one sends his data via wireless (cisco AP) on vlan 2.

Has anybody already made this kind of installation?

Thankx for your support.
3 REPLIES
Pieter 't Hart
Honored Contributor

Re: Problem Tagging between Switch Procurve_1700-24 and AP Cisco_1240

>>>
There is no traffic on vlan 2 between 1st laptop connected on 1700-24_Port 24 with Traffic = Tagged only - vlan 2
<<<

Don't configure this port as tagged-only, but untagged in vlan-2!

normally a laptop does NOT send tagged packets.
and "tagged-only" port will not accept untagged packets.

Pieter
Djuma Cauwenbergh
Occasional Visitor

Re: Problem Tagging between Switch Procurve_1700-24 and AP Cisco_1240

Hi Pieter,

It's OK now.

I didn't thought about it.

Best regards,

Djuma

Djuma Cauwenbergh
Occasional Visitor

Re: Problem Tagging between Switch Procurve_1700-24 and AP Cisco_1240

Ports were are all stations connected must be "PACKET TYPE = ALL" & PVID