Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem logging in Web in stack

Varyag
Occasional Contributor

Problem logging in Web in stack

Hello!

I create a stack contains 2 switches HP ProCurve 2650.

sw0(IP 192.168.1.1) - commander
sw1(IP 192.168.1.2) - member

Manager credentials are the same in 2 swithes.

I login to sw0 with manager credentials in Web interface(http://192.168.1.1). After that in menu I want to go to sw1 for configuring it. After I redirected to sw1 Webinterface ask me login and password. I enter correct credentials but system ask me again. I cannot login after redirect from sw0.

If I go directly to sw1 Web interface (http://192.168.1.1) - I can login using same credentials.

I don't know why this happen.

Does anyone have the same problem?




1 REPLY

Re: Problem logging in Web in stack

Hi

I see you have already Ip address configured on both switches.

I would actually recommend you to turn off stacking.

The main point of stacking is to "save" ip addresses. So typically you would only configure ip address on the commander.

http://www.hp.com/rnd/device_help/help/hpwnd/webhelp/HPJ4093A/configuration_stacking.htm