Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem with 2510B-24 (J9019B) and PCM+

SOLVED
Go to solution
Matias Hannus
Occasional Contributor

Problem with 2510B-24 (J9019B) and PCM+

I have about 85 switches set up in PCM+ and it works pretty good. I have had a couple of 2510-24 (J9019A) and no problem there but now when I bought ten more I got the newer version 2510B-24 (J9019B) and it doesn't go along with PCM+ all that well...

I have upgraded the new switches with the latest software Q.11.11 and autoupdate package #5 (which include support for J9019B) and also the latest #6 are installed in PCM+.

Ok so what's the problem? Well PCM+ recognizes the 2510B-24 as a 1800-24G-B (J9028B)!

This is a short version of what the Dashboards properties states:

Manufacturer: Hewlett-Packard
Model: 1800-24G-B
Model Number: J9028B
ROM: ---
SW Version: ---
Serial Number: ---
System description: ProCurve J9019B Switch 2510B-24, revision Q.11.11, ROM Q.10.02 (/sw/code/build/harp(bh2))

What's going on here? I have included a screenshot.
2 REPLIES
Franklyn
Frequent Advisor
Solution

Re: Problem with 2510B-24 (J9019B) and PCM+

Hi Matias,

The issue has been resolved with a later firmware revision, contact your local Procurve Support


Good Luck!
Matias Hannus
Occasional Contributor

Re: Problem with 2510B-24 (J9019B) and PCM+

Thank you Franklyn! I now found this old similar thread: http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=1263568

I will try to get Q.11.13 from the local support.