Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Problems with ProCurve1800 after FW upgrade

SOLVED
Go to solution
Superdust
Advisor

Problems with ProCurve1800 after FW upgrade

Hello

I upgraded a ProCurve Switch 1800-24G (J9028B) to firmware PB.03.02

After the upgrade I cannot choose witch VLAN should be untagged.
The PVID field only contains VLAN1.

I tried resetting to factory defaults, and adding VLANs again, but still the same.

So I decided to downgrade to get the system up again, but now I cannot downgrade to older FW than PB.03.01, and this release I cannot find.

Need some quick tips here to get the system running...
2 REPLIES
Mohammed Faiz
Honored Contributor
Solution

Re: Problems with ProCurve1800 after FW upgrade

Hi,

Have you tried the full-blown factory reset? (page 52)

http://cdn.procurve.com/training/Manuals/1800-MgmtCfg-June2007-59916275.pdf
Superdust
Advisor

Re: Problems with ProCurve1800 after FW upgrade

That did the trick, thank you!

I actually tried the hard reset first, but it would not work.

For it to work I had to disable the multicast rate limit setting.

The setup on this switch really sucks, still with new firmware.