Procurve 2520-24G-PoE "losing" (not showing) configuration

[hkth]

We have several (>20) 2520-24G's, which all exhibit the following behaviour: after some uptime (~24 h) they stop displaying their configuration through CLI:

sw1-203b# show running-config

Running configuration:

; J9299A Configuration Editor; Created on release #J.14.54

sw1-203b# show config

Startup configuration:

; J9299A Configuration Editor; Created on release #J.14.54

The switches seem to be working OK and most pther show-command perform as expected. As you can see, we have the latest and greates software in the switches (the older version (J.14.01) worked OK in this respect, but had a painfully slow response over SSH. I have no taken to rebooting the switch every time something needs to be changed, as can't be sure, what would happen, if I changed and saved the config. Is there a work-around for this glitch?

[Peter Kanters_1]

Same here, we have 10 switches which all have the same symptoms. (firmware 14.54)

Also the GUI gives only java errors. in all browsers (IE, Chrome, Firefox)

After a reboot the switch functions normal, and the config is restored.

Does anybody have a solution for this problem.

Thnx

[RIchITSupport]

Same here. We have 3 of these switches with firmware 14.54. Exactly as described - seems to work OK but does not show the running config. Re-booting the switch sorts it, but after 24 hours or so, the config will not be displayed again.

[Arimo]

Hi guys

I've not heard about this. Please call support.