Procurve 2524 Port Counte reset - only temporary

[Bullii]

I want to reset the counters from the Ports of my 2524`s. However, this is only temporary. I give the command "clear statistics 1-24 ehternet" these resets only until the next login, and then again the old values.About the text-based reset exactly the same result.Firmware is up to date.

[Erdogan Temur]

Hi,

This should help,you look at page 49.
http://www.hp.com/rnd/pdfs/CLI_reference.pdf

regards.
Erdogan

[Bullii]

Ein Reset über das CLI bringt leider nichts. Nach einem erneutem Login sind die Werte wieder auf dem alten Stand

[Bullii]

A reset through the CLI does not, unfortunately. After a login again, the values back to the old status

[Erdogan Temur]

first update firmware and than try again.

http://www.procurve.com/customercare/support/software/summarypages/f-j4812-c.htm

regards.
Erdogan

[Arimo]

Hi

Sorry mate, the only way to clear the stats permanently is to power cycle the unit.


HTH

[f0rgiv3n]

I had the same question and contacted support. I had the support rep attempt "clear stats global" on a test switch. That seems to have done it. I did it on mine and it now has all the stats cleared and when I close my session and open it back up it's still cleared.