Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Procurve 2524 Port Counte reset - only temporary

 
Bullii
Occasional Contributor

Procurve 2524 Port Counte reset - only temporary

I want to reset the counters from the Ports of my 2524`s. However, this is only temporary. I give the command "clear statistics 1-24 ehternet" these resets only until the next login, and then again the old values.About the text-based reset exactly the same result.Firmware is up to date.
6 REPLIES

Re: Procurve 2524 Port Counte reset - only temporary

Hi,

This should help,you look at page 49.
http://www.hp.com/rnd/pdfs/CLI_reference.pdf

regards.
Erdogan
Kind Regards,
Erdogan.
I am HPE Employee

If this helps you with your issue, please click the thumb to register a Kudo.
If it resolves the issue, please consider marking it as an Accepted Solution.
The comments in this post are my own and do not represent an official reply from the company. No warranty or guarantees of any kind are expressed in my reply.
Bullii
Occasional Contributor

Re: Procurve 2524 Port Counte reset - only temporary

Ein Reset über das CLI bringt leider nichts. Nach einem erneutem Login sind die Werte wieder auf dem alten Stand
Bullii
Occasional Contributor

Re: Procurve 2524 Port Counte reset - only temporary

A reset through the CLI does not, unfortunately. After a login again, the values back to the old status

Re: Procurve 2524 Port Counte reset - only temporary

first update firmware and than try again.

http://www.procurve.com/customercare/support/software/summarypages/f-j4812-c.htm

regards.
Erdogan
Kind Regards,
Erdogan.
I am HPE Employee

If this helps you with your issue, please click the thumb to register a Kudo.
If it resolves the issue, please consider marking it as an Accepted Solution.
The comments in this post are my own and do not represent an official reply from the company. No warranty or guarantees of any kind are expressed in my reply.
Arimo
Respected Contributor

Re: Procurve 2524 Port Counte reset - only temporary

Hi

Sorry mate, the only way to clear the stats permanently is to power cycle the unit.


HTH

HTH,

Arimo
HPE Networking Engineer
f0rgiv3n
Occasional Visitor

Re: Procurve 2524 Port Counte reset - only temporary

I had the same question and contacted support. I had the support rep attempt "clear stats global" on a test switch. That seems to have done it. I did it on mine and it now has all the stats cleared and when I close my session and open it back up it's still cleared.