HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Procurve 2524 ignore Tagging from a Procurve AP 420

 
NetrunnerAT
Occasional Contributor

Procurve 2524 ignore Tagging from a Procurve AP 420

The Access Point can Switch Wireless Users in different VLANs. OK ... my Problem ... the Switch is config to Tagging and the AP too, but it doesnt Work!

I have check the Config from Switch and AP. Have the newest Firmware. VLAN Support is Dynamic on the AP. Both SSIDs are enabled and have a exist VLAN ID. I can only Ping a IP if the Switch have the Port from AP on any VLAN untagged!!!!
1 REPLY
Jason F.
Advisor

Re: Procurve 2524 ignore Tagging from a Procurve AP 420

In order to get assistance, please reply with "show tech" of switch and screenshots of the SSID setup of your 420.

-Jason
ProCurve Support