HPE Community
Switches, Hubs, and Modems
1753969 Members
7250 Online
108811 Solutions
New Discussion

Re: Procurve 2524 not responding

 
Daniel Wood
Occasional Contributor

‎05-09-2003 09:59 AM

‎05-09-2003 09:59 AM

Procurve 2524 not responding

I have a brand new Procurve 2524 that doesn't seem to be responding. I'm connected via HyperTerminal, and when I boot up the switch, it goes through decompressing the image, verifying the image, then initializing, then it gets to this line and halts:

Waiting for Speed Sense. Press twice to continue.

At that point it stops, and will not respond to any input. What can I do?
"I think America causes cancer, longevity is less important than fun, and young people should be discouraged from voting.... I think children are not innocent, God doesn't write books and Jesus wasn't a Republican." -- Bill Maher
0 Kudos
1 REPLY 1
Arimo Laine_2
Valued Contributor

‎05-12-2003 07:12 AM

‎05-12-2003 07:12 AM

Re: Procurve 2524 not responding

Hi.

Easy enough... don't use Hyperterminal. Check out Tera Term Pro; http://hp.vector.co.jp/authors/VA002416/teraterm.html

HTH,
Arimo
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.