- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- Procurve 2524 setup syslog
Switches, Hubs, and Modems
1753300
Members
7032
Online
108792
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-23-2011 10:12 AM
02-23-2011 10:12 AM
Procurve 2524 setup syslog
I have a simple question about setting up sysloging on this switch. When I issue the logging
command I get an error about
invalid input: logging
Do I not have rights to that command?
I'm issuing it at the switch# prompt.
Thanks
command I get an error about
invalid input: logging
Do I not have rights to that command?
I'm issuing it at the switch# prompt.
Thanks
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-23-2011 10:42 AM
02-23-2011 10:42 AM
Re: Procurve 2524 setup syslog
edit: I did this at the switch(config)#
but the logging command doesn't exist.
I also noticed I get a similiar error with the command "show debug" invalid input: debug
Is it possible this switch doesn't support these commands?
HP J4813A Procurve 2524
Firmware: F.05.17
but the logging command doesn't exist.
I also noticed I get a similiar error with the command "show debug" invalid input: debug
Is it possible this switch doesn't support these commands?
HP J4813A Procurve 2524
Firmware: F.05.17
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP