HPE Community
Switches, Hubs, and Modems
1751900 Members
4821 Online
108783 Solutions
New Discussion

Procurve 2524 setup syslog

 
cfut
New Member

‎02-23-2011 10:12 AM

‎02-23-2011 10:12 AM

Procurve 2524 setup syslog

I have a simple question about setting up sysloging on this switch. When I issue the logging
command I get an error about
invalid input: logging

Do I not have rights to that command?
I'm issuing it at the switch# prompt.
Thanks
0 Kudos
1 REPLY 1
cfut
New Member

‎02-23-2011 10:42 AM

‎02-23-2011 10:42 AM

Re: Procurve 2524 setup syslog

edit: I did this at the switch(config)#
but the logging command doesn't exist.

I also noticed I get a similiar error with the command "show debug" invalid input: debug

Is it possible this switch doesn't support these commands?

HP J4813A Procurve 2524
Firmware: F.05.17
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.