Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Procurve 2650 using VLANS sent via IAS

Nikil Deo
Occasional Advisor

Procurve 2650 using VLANS sent via IAS

Hi,
I am trying to setup a network using 802.1x authentication where ports are assigned a vlan id via radius.

I have seen the various foundry documents and have got this working. When IAS sends the vlan to the switch, the switch places the port in a web vlan mode as opposed to tagged or untagged.

I am wondering is it possible for IAS to send a string to the hp 2650 which will allow it to place a port in vlan 2 as tagged and vlan 3 as untagged.

the foundry network documents indicate this is possible on their switches, does HP have a similar command or attribute I can use to acheive the same thing?
2 REPLIES
Matt Hobbs
Honored Contributor

Re: Procurve 2650 using VLANS sent via IAS

Which Foundry document are you referring to?

The only way I believe you can do this on a ProCurve switch is to statically set the port for the tagged VLANs that it may require, and let RADIUS assign the untagged VLAN.

Nikil Deo
Occasional Advisor

Re: Procurve 2650 using VLANS sent via IAS

Hi Matt,

thanks for the reply
i'm referring to this document
http://www.foundrynet.com/pdf/wp-deploying-mac-with-ias.pdf

oh page 46 it mentions sending untagged and tagged vlan information to the switch, I was hoping HP switches have similar attributes that we could use.

Thanks.