Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Procurve 802.1x wired autehntication

Sallas
Occasional Visitor

Procurve 802.1x wired autehntication

Hi, I have a problem.

I specify 2 radius server for port access 802.1x authentication.

radius-server host 10.17.0.254 key xxxxx
radius-server host 10.17.0.200 key xxxxx

 

But if i stop the radius server on 10.17.0.254, -  authentification fails.

It does't use secondaryt radius server.

 

 

2 REPLIES
RickL
Frequent Advisor

Re: Procurve 802.1x wired autehntication

I beleive it might have to do with the timeout length. Try:

 

radius-server timeout 1

 

You can also specify the retransmit value:

 

radius-server retransmit 1

 

You may need to up these values, but they should help.

 

Rick

Sallas
Occasional Visitor

Re: Procurve 802.1x wired autehntication

Hi,

 

Thanks for reply,

I registered case in HP, and they recommended the same solution. Reduce radius server time-out to 3.

After doing this, everything working fine.

Hp also said, that they are thinking to reduce default timeout in future firmware realeases.