Procurve 9315m and SLB Teaming

[stefano colombo_1]

We have a procurve 9315m as core switch which P-Class Blade are connected to.
I'd like to configure the Blade NIC teaming as SLB .

So I looked for a way to configure the 2 ports on the switch as trunk , but couldn't find it in the WEB configuration page .
The trunk configuration page is not very clear .

Can anyone provide me instructions to correctly configure the SLB from the switch side , using CLI ?

Thanks a lot

[Joel Belizario · Accepted solution]

Hi Stefano,

The information you are after is in the documentation for the 9313m from HP ProCurve's website.

http://www.hp.com/rnd/support/manuals/93xx_6308.htm

Below is the chapter specific to trunking:

ftp://ftp.hp.com/pub/networking/software/9300m-Install-Jun2005-59906028-Chap07.pdf

Just be aware that deploying trunks will require a reload on certain versions of firmware to deploy and generally speaking will require a reload across all versions at some stage.

Good luck!

Joel