Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Procurve Fault Finder Application

SOLVED
Go to solution
Imad Odeh
Occasional Contributor

Procurve Fault Finder Application

Hi,
I have so many errors in the events page of my procurve software which I would like to know the cause and how to resolve it. I have read in the Procurve help about the "FAULT FINDER APPLICATION", but I do not know where it is and how to activate it on the Procurve software.

Any help is appreciated.

Thanks in advance,

Imad
E-mail:imadodeh@gmail.com
1 REPLY
Matt Hobbs
Honored Contributor
Solution

Re: Procurve Fault Finder Application

Hi Imad,

If you are seeing a lot of fault finder errors in the switch event log, you can change the sensitivity of the fault finder:

4108(config)# fault-finder
all All fault types.
bad-driver Too many undersized/giant packets.
bad-transceiver Excessive jabbering.
bad-cable Excessive CRC/alignment errors.
too-long-cable Excessive late collisions.
over-bandwidth High collision or drop rate.
broadcast-storm Excessive broadcasts.
loss-of-link Link lost detected.
sensitivity Define fault finder sensitivity to events.

4108(config)# fault-finder all sensitivity low