Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Procurve Secure Router 7102dl - Frame Relay Config

networknaz
Advisor

Procurve Secure Router 7102dl - Frame Relay Config

Hi All,

Can any one help me to resolve this issue.

1. Attached Design and config

1. Created and configured a Frame Relay interface.

2. Created and configured a sub interface.

3. Bind physical interface to the Frame Relay interface

4. Configured LMI type intf signaling as CISCO ( Because Remote Router Configured as CISCO)

5. show interfaces (serial , ethernet) and line protocol is - UP

6. show frame-relay lmi - UP

7. show frame-relay pvc - Active

8. cleared counters on fr1

9. Checked information about Neighbor devices -

show lldp neighbors interface (enter interface no ) detail - Unable to see remote devices

10. Specified routes for other segments.

11. Router is running latest firmware.

12. Serial Interface is up and Line protocol is up but unable to ping other end ip (10.1.21.77)

13. Attached design and latest config (CISCO config also attached which is working fine)

14. Router is running with latest firmware.


Regards

Network Naz
2 REPLIES
cenk sasmaztin
Honored Contributor

Re: Procurve Secure Router 7102dl - Frame Relay Config

hi
please send me other cisco router show run print

cenk
cenk

cenk sasmaztin
Honored Contributor

Re: Procurve Secure Router 7102dl - Frame Relay Config

not include lldp protocol cisco device
therefore you not see lldp info on your procurve router.

ı think your problem due to routing

please send me other router show run print

cenk
cenk