Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

QOS over fibre connection

ggggum23
Occasional Visitor

QOS over fibre connection

We have a 100MB fibre joining two sites which has historically been a data only link. It is presented via RJ45 at both ends. We now need to run data and VOIP phones over this connection . The VOIP system and the data network is on physically separate switches and IP ranges at both ends. How can i setup switches at both ends of the fibre to reserve 10mb of the Fibre Bandwidth for the voice traffic  and 90mb  over the fibre link ? The switches at the end of the fibre will only have two cables plugged into them , one to the data switch and one to the Voip switch.

 

Thanks