Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

QoS HP 2620 switch

tommysvensson0
Occasional Visitor

QoS HP 2620 switch

Hi.

 

I have the following setup:

 

LAN1 ----- Router1-------

LAN2 ----- Router2-------Switch1-------HP 2620-------Internet

LAN3 ----- Router3-------

 

What i need from the HP 2620 switch is to be able to restrict LAN1, 2 and 3 to 5 Mbit bandwidth each on this 30 Mbit Internet connection. My guess is to do this based on either IP address or MAC address of Router 1, 2 and 3. 

 

My question is that if its possible to make this happen with the HP 2620 switch? And if so, what kind of configuration should i use? See below wich kind of QoS techniques that is supported.

 

From HP Quick Specs:

Quality of Service (QoS)

Layer 4 prioritization: enables prioritization based on TCP/UDP port numbers
Traffic prioritization (IEEE 802.1p): allows real-time traffic classification into eight priority levels mapped to eight queues
Class of Service (CoS): sets the IEEE 802.1p priority tag based on IP address, IP Type of Service (ToS), Layer 3 protocol,
TCP/UDP port number, source port, and DiffServ
Rate limiting: sets per-port ingress enforced maximums and per-port, per-queue guaranteed minimums

 

Kind regards,

 

Tommy

1 REPLY
giusca
Occasional Visitor

Re: QoS HP 2620 switch

have you gotten an answer?

You can configure ingress port rate limiting and reduce the ingress of LAN1,2,3 to the wanted Mbps