- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- RSTP Ring Settings
Switches, Hubs, and Modems
1753971
Members
7861
Online
108811
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2007 01:36 AM
06-13-2007 01:36 AM
RSTP Ring Settings
As per a prevous post I created an OE Ring in our datacentre core with a 6400 and 3 3400's with 10GB links. I enabled RSTP and allowed it to choose the port to block on the ring. However it appears that RSTP may be recalculating and is dropping network connections. I then changed the default cost on the currently blocked link from 2000 to 2001 and changed the priority from 8 to 9. I am assuming this should prevent it from changing the topology every time it recalculates. I still want this link to be checked (in case of a link failure) but I was hoping the recalcuation would be more transparant to the endusers. Are there any more tweaks I can use?
Thanks
Thanks
Thanks
Thanks
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2007 03:38 AM
06-13-2007 03:38 AM
Re: RSTP Ring Settings
both the 3400s and the 6400s support procurve meshing, if you were to use this all links would be in use at the same time using the shortest routes, if you lost one of the links in the ring it would go switch as a stack of switches.
set the port type to mesh and your away.
set the port type to mesh and your away.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP