Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Removing one member from a stack

psycho.chicken
Regular Advisor

Removing one member from a stack

How do i remove a member from a stack?

I'm following a HP Doc but some of the commands arent showing up/working

Via CLI or Menu is fine
2 REPLIES
Matt Hobbs
Honored Contributor

Re: Removing one member from a stack

Through the web interface it's very straight forward from memory.

Otherwise from the CLI you could try 'no stack' and then 'stack auto-join' to renable it.

Or do 'no stack join '

When you do 'show run' it will show you the mac-address of the Commander that you need to specify.

Alternatively from the Commander going through the telnet Menu, you can go into the stack management menu and delete the switch from there.
psycho.chicken
Regular Advisor

Re: Removing one member from a stack

I figured it out...

I was noton the commander, so all the options were not available...

dah...