HPE Community
Switches, Hubs, and Modems
1753905 Members
9821 Online
108810 Solutions
New Discussion

Replace switch config using PCM

 
Ronnie Hamilton_1
Frequent Advisor

‎06-27-2007 02:52 AM

‎06-27-2007 02:52 AM

Replace switch config using PCM

Hi,
had a switch failure, and have eventually received its replacement. Whats the best way to use the con fig that I have saved in PCM to redeploy the new switch. Same model it just needs exact con fig pushed out.

cheers
ROn
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.