- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- Resetting "Learn Mode" on ProCurve Switches
Switches, Hubs, and Modems
1753894
Members
7585
Online
108809
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-08-2006 03:36 PM
09-08-2006 03:36 PM
Resetting "Learn Mode" on ProCurve Switches
I have a number of ProCurve switches however they're remembering old MAC addresses when I switch them from Continous to Static, how do I reset this so they re-learn what is actually attached?
Cheers, Chris.
Cheers, Chris.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-08-2006 05:13 PM
09-08-2006 05:13 PM
Re: Resetting "Learn Mode" on ProCurve Switches
Hi
The Continous mode is the default, but when the static-learn option enabled, you authorize specific devices for the port, while still allowing the port to accept other,non-specified devices until the port reaches the configured address limit (if you configured).
So what you need is to let the switch age-out previous MAC-addresses.
Or
if you configured the address limit, then lower the address-limit first by one number and remove the specific MAC address, so it can;t be learned any more.
Good Luck !!!
The Continous mode is the default, but when the static-learn option enabled, you authorize specific devices for the port, while still allowing the port to accept other,non-specified devices until the port reaches the configured address limit (if you configured).
So what you need is to let the switch age-out previous MAC-addresses.
Or
if you configured the address limit, then lower the address-limit first by one number and remove the specific MAC address, so it can;t be learned any more.
Good Luck !!!
Science for Everyone
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP