- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- Route entry priority setting in ProCurve 2650
Switches, Hubs, and Modems
1753809
Members
7972
Online
108805
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-12-2009 07:31 PM
02-12-2009 07:31 PM
Route entry priority setting in ProCurve 2650
Is it possible to set higher priority for an entry in the routing table than other entries?
The reason for putting up this question is: i have one network 192.168.0.0/24, and another subnet 192.168.0.0/26, i want all traffic go to the more specific subnet 192.168.0.0/26 instead of going to 192.168.0.0/24 when i ping 192.168.0.60 on the switch.
The reason for putting up this question is: i have one network 192.168.0.0/24, and another subnet 192.168.0.0/26, i want all traffic go to the more specific subnet 192.168.0.0/26 instead of going to 192.168.0.0/24 when i ping 192.168.0.60 on the switch.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2009 12:09 AM
02-13-2009 12:09 AM
Re: Route entry priority setting in ProCurve 2650
It should be working automaticly, since a route entry with a longer mask will have higher priority over a shorter mask.
I.e.
10.0.0.0/8 > route 1
10.25.40/24 > route 2
Then traffic matching the second line will go to route 2.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP