Switches, Hubs, and Modems
1748027 Members
4900 Online
108757 Solutions
New Discussion юеВ

Re: Saving routing table

 
Ashok K Gurung
Frequent Advisor

Saving routing table

Hi

we are having problem saving static routing table.

We used command "ip route 0.0.0.0 0.0.0.0 172.16.32.1"

172.16.32.1 is our firewall. we used command like write memory but when ever we reboot switch for some reason route we enter will be disapear.

is there any thing we need to do to save this thing parmanently?

we will appreciate if any one could advice us on this.

Thank you
15 REPLIES 15
Matt Hobbs
Honored Contributor

Re: Saving routing table

That's strange, which switch are you using and have you updated the firmware to the latest version?
Ashok K Gurung
Frequent Advisor

Re: Saving routing table

Yes that is what i am thinking

We have just installed latest version below is our firmware info


HP ProCurve Switch 5308xl# show version
Image stamp: /sw/code/build/alpmo(m35)
Apr 13 2007 14:19:50
E.10.61
891
Boot Image: Primary

Thank you
Joel Belizario
Trusted Contributor

Re: Saving routing table

After you do the write memory is the startup config updated?
Ashok K Gurung
Frequent Advisor

Re: Saving routing table

Hi again

What is the cammand to see what is in startup config?

When i do write memory everything else gets saved e.g. vlan setting so on

I am not sure if this related or not we do not have any rip, pim or ospf enabled. we just have IP routing enabled and that just need to do intervaln routing.

We needed this on to work as default gateway to the outside world.

Thank you
Thank you
Joel Belizario
Trusted Contributor

Re: Saving routing table

Should be just a "show startup-config", also a "show running-config status" should tell you whether there are differences between the startup and running configs.

Hope this helps!


Ashok K Gurung
Frequent Advisor

Re: Saving routing table

Hi & Thanks for your reply again

there is no command "show startup-config" availabe to us but when we chaecked with "show running-config status" it says "Running configuration is same as the startup configuration."

I am not sure where did we do wrong.

Thank you
Joel Belizario
Trusted Contributor

Re: Saving routing table

Sorry my mistake, it should be just a "show config" to see the startup config, am doing this from memory.
Ashok K Gurung
Frequent Advisor

Re: Saving routing table

yes i can see route entry when we do show config

Thank you
Joel Belizario
Trusted Contributor

Re: Saving routing table

Is the route still disappearing when you reload the switch?