Setting 2810-24G to STP Protocol

[Josef Müller]

In the Advanced Traffic Management Guide for 2810 at 5-17 is the following Note:

"The switch supports MSTP configuration through the CLI. After you specify MSTP and reboot the switch as described above, the switch removes the Spanning Tree option from the Menu interface. If you later reconfigure the switch to use STP or RSTP, the switch returns the Spanning Tree option to the Menu interface."

I want t use STP (not RSTP or MSTP) and confguring STP with the menu interface. How can I set the switch to use STP and showing the menu interface as described in the Advanced Traffic Management Guide?

I tried "spanning-tree legacy-mode", but this did´nt work.

Thanks!

[Michael_Breuer · Accepted solution]

Hi Josef,

to run the switch in 802.1D STP mode use the command:

spanning-tree force-version stp-compatible

Maybe a reboot is required.

Cheers,

Michael

[Josef Müller]

Hello,

after using the command you recommended
the switch now works in the mode i need.

Thanks!

Josef Mueller

[Josef Müller]

Thread closed,

Thanks again.