Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Setting 2810-24G to STP Protocol

SOLVED
Go to solution

Setting 2810-24G to STP Protocol

In the Advanced Traffic Management Guide for 2810 at 5-17 is the following Note:

"The switch supports MSTP configuration through the CLI. After you specify MSTP and reboot the switch as described above, the switch removes the Spanning Tree option from the Menu interface. If you later reconfigure the switch to use STP or RSTP, the switch returns the Spanning Tree option to the Menu interface."

I want t use STP (not RSTP or MSTP) and confguring STP with the menu interface. How can I set the switch to use STP and showing the menu interface as described in the Advanced Traffic Management Guide?

I tried "spanning-tree legacy-mode", but this did´nt work.

Thanks!
3 REPLIES
Michael_Breuer
Esteemed Contributor
Solution

Re: Setting 2810-24G to STP Protocol

Hi Josef,

to run the switch in 802.1D STP mode use the command:

spanning-tree force-version stp-compatible

Maybe a reboot is required.

Cheers,

Michael
Ingentive Networks GmbH

Re: Setting 2810-24G to STP Protocol

Hello,

after using the command you recommended
the switch now works in the mode i need.

Thanks!

Josef Mueller

Re: Setting 2810-24G to STP Protocol

Thread closed,

Thanks again.