Switches, Hubs, and Modems

Re: Setup VLAN on Procurve 2626

 
cenk sasmaztin
Honored Contributor

Re: Setup VLAN on Procurve 2626

hi Kelly

I send to you two config config one one inbound interface router and two network runing

tag port no shuch thing gvrp
tag port so tagged port carying many vlan id on same port

my frist config one router interface cary two network to switch

other config for example create vlan on hp switch

I hope you understand me

if you want create vlan on hp switch
must be write this command

ProCurve Switch 2610-24(config)# vlan 172
ProCurve Switch 2610-24(vlan-172)# untag 17
ProCurve Switch 2610-24(vlan-5)# ip address 192.168.172.99/24
ProCurve Switch 2610-24(vlan-172)#wr mem



cenk

kwilke
Advisor

Re: Setup VLAN on Procurve 2626

Hello,
Okay I will do the create the VLAN on the switch.
I will have to wait until tomorrow morning to do this since the switch is being used the rest of today.
I will let you know how it works.
Thank you,
Kelly W.
Pieter 't Hart
Honored Contributor

Re: Setup VLAN on Procurve 2626

>>>
In port 17, I currently have a Cisco device that is being used as a NAT device
<<<
probably you only need routing between two networks ?
if you really need NAT, text below is not sufficient.

if so you need to
- create vlan
- select subnets for each vlan (192.168.x.0/24)
- give switch ip-adress in in each vlan (192.169.x.1)
- enable routing
- assign ports as "untagged" in respective vlan
- configure connected host to use switch ip-adress as default gateway


like Cenk sayd use vlan-1 only for management

vlan 1
name "DEFAULT_VLAN"
ip address 192.168.1.1 255.255.255.0
untagged 1
no untagged 2-28
exit
(only port1 can reach this management vlan directly)

vlan 10
name "localhosts"
untagged 2-16, 18-26
no untagged 1, 17
ip address 192.168.10.1 255.255.255.0
exit

vlan 172
name "oldCiscoport"
untagged 17
no untagged 1-16, 18-26
ip address 192.168.172.99 255.255.255.0
exit
ip routing

the localhosts must use 192.168.10.1 as gateway to reach the 192.168.172.0 network
if there are other subnets behind this port
the switch also needs a default-router on this subnet.
ip route 0.0.0.0 0.0.0.0 192.167.172.x

and offcourse the devices in 192.168.172.0 network must know a (default) route back to reach 192.168.10.0 devices
kwilke
Advisor

Re: Setup VLAN on Procurve 2626

Hello,
Well this failed miserably so I guess I need to call tech support to figure out what to do.
Thanks,
Kelly W.