Spanning Tree config via menu on an ProCurve 2610-48 PWR

[aspectmeyer]

Hi,

I have a new ProCurve 2610-48 PWR Switch with the latest firmware. Within the menu, there is no option to configure spanning tree. On the commandline I can configure it. Does I need configure something to get the spanning tree point in the menu?

[Pourl]

U can enable stp under "run setup" in main menu. But I didn't found detail configurations. I would configure it via cli.

[aspectmeyer]

on my other ProCurve switches i have an detail setup for stp under "Main Menu -> 2. Switch Configuration ->  4. Spanning Tree Operation".

The Option for enable stp under "run setup" I already tried, even with a restart of the switch.

[Richard Brodie_1]

It's been disappearing from the menu  for a while:

http://h30499.www3.hp.com/t5/Switches-Hubs-Modems-Legacy-ITRC/Spanning-tree-menu-not-displayed-with-latest-fw/m-p/4055415/highlight/true#M12299

[aspectmeyer]

Tanks, this explains why I can not activate it.