Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Spanning Tree config via menu on an ProCurve 2610-48 PWR

aspectmeyer
Occasional Visitor

Spanning Tree config via menu on an ProCurve 2610-48 PWR

Hi,

 

I have a new ProCurve 2610-48 PWR Switch with the latest firmware. Within the menu, there is no option to configure spanning tree. On the commandline I can configure it. Does I need configure something to get the spanning tree point in the menu?

4 REPLIES
Pourl
Frequent Advisor

Re: Spanning Tree config via menu on an ProCurve 2610-48 PWR

U can enable stp under "run setup" in main menu. But I didn't found detail configurations. I would configure it via cli.

aspectmeyer
Occasional Visitor

Re: Spanning Tree config via menu on an ProCurve 2610-48 PWR

on my other ProCurve switches i have an detail setup for stp under "Main Menu -> 2. Switch Configuration ->  4. Spanning Tree Operation".

 

The Option for enable stp under "run setup" I already tried, even with a restart of the switch.

Richard Brodie_1
Honored Contributor

Re: Spanning Tree config via menu on an ProCurve 2610-48 PWR

aspectmeyer
Occasional Visitor

Re: Spanning Tree config via menu on an ProCurve 2610-48 PWR

Tanks, this explains why I can not activate it.