Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Switch Problem

CharlesBagworth
Occasional Visitor

Switch Problem

Hi

 

We have a few switches that have 802.1 enable, there are multiple vlans setup for different services. We are trying to add a Wireless AP to the network and want to disable 802.1x on specific ports, I can add the port to the vlan untagged which isn't a problem, the problem is the mode is 802.1x not untagged when I do a show vlans, I need to remove this mode asap

 

thanks

2 REPLIES
Sietze Reitsma
Respected Contributor

Re: Switch Problem

In that case you need to turn off 802.1x authentication on the port by:

 

cli:

no aaa port-access authenticator [portnumber]

 

I believe it's above command

CharlesBagworth
Occasional Visitor

Re: Switch Problem

I had tried almost every combination but must have missed that one.

 

that has removed the 802.1x mode.

 

I still cannot see the access point from the management device tho,

 

any ideas

 

thanks