Community
Switches, Hubs, and Modems
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Thanks I got Solution.

 
Charanjit Singh
Occasional Contributor

‎02-21-2011 12:09 PM

‎02-21-2011 12:09 PM

Thanks I got Solution.

Hi

I have renamed the eth0 to eth2 and eth1 to eth3 and did with eth2 and eth3 vice versa of ifcfg-eth* files in linux and in ifcfg-eth* configuration files I changed the MAC addresses with their respective ethernet cards, I rebooted it and it solved my problem . Thanks for solution.

Regards
CJ
0 Kudos
2 REPLIES 2
Navya Sri
Frequent Advisor

‎02-21-2011 08:39 PM - last edited on ‎09-02-2011 08:02 AM by

‎02-21-2011 08:39 PM - last edited on ‎09-02-2011 08:02 AM by

Re: Thanks I got Solution.

Hi Charanjit Singh,

I believe you intended to reply here:
http://h30499.www3.hp.com/t5/Switches-Hubs-Modems-Legacy-ITRC/Problem-in-switch-HP-BLc-GbE2c-LY-2-3-Switch/m-p/5274407#M30027

Please click on "Reply" instead of "Start New Thread" while replying to an existing thread. It is difficult for forum members to backtrack to the original query, if you start a new thread.

Since this is a duplicate thread, I suggest you to close this duplicate thread using "Close thread" and continue your dicussion in the above mentioned thread.


Thanks&Regards,
Navya.

0 Kudos
Charanjit Singh
Occasional Contributor

‎03-14-2011 07:33 AM

‎03-14-2011 07:33 AM

Re: Thanks I got Solution.

Thanks, apologies I will take care in future
This Thread is Closed..
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.