Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

The GbE2 switch and the new Enhanced management module ILO port

Steve Savinelli
Occasional Contributor

The GbE2 switch and the new Enhanced management module ILO port

Hello,

We recently upgraded one of our blade enclosures with the new Enhanced BP kits. In We also run the GbE2 switches in all our enclosures as well. In the upgrade kit, A "jumper" cable was included to wire the single ILO port to one of the ports on the front of the switch. We have done this and enabled the VLAN that we use for management on that port. To no avail, we can not get the ILO working again. The ILO was statically addressed, and work prior to the upgrade.
Has anyone faced this problem yet or am I missing something in setup?

The port on the switch is configured just for that Vlan and is set to 100 FULL, It also looks like it is sending and receiving packets. It is hooked up to the "B" side switch.

1 REPLY
Jason Scott
Regular Advisor

Re: The GbE2 switch and the new Enhanced management module ILO port

Hi Steve,

I'm afraid my reply isn't an answer to your question, but I was wondering if you could be kind enough to provide details of how you have your GbE2 switches connected to your LAN? Specifically do you have redundant trunked links to your core switches? If so how have you configured them for spanning tree, trunking and vlan support?

Thanks in advance,

Jason