Trunked NIC Won't Route Through 2910al-48

[jsu]

We have been trunking a NC364T QP NIC to Procurve 2848 and 2900-48 switches for awhile. Our first 2910al-48 came in and I'm having a devil of a time. Static and Dynamic trunks can be created, but the teamed NIC won't route properly through the switch. The switch is running 5 VLANs - All the other VLANs work just fine (albeit nothing else is teamed/trunked).

Setting the team with a static ip address doesn't work, as no different than setting it for DHCP (can't connect to the DHCP server to pick up network properties).

Unteamed, the individual QP nics connect just fine.
- DL380G5 x64 W2K3
- NC364T QP NIC s/w: 9.12.36.0
- HP NCU 9.70.0.15
- Procurve 2910al-48 s/w: W.13.29 or 30, the switch is running 5 VLANs.

The log reports a few anomalies... like a few ports flopping... probably because they are connected to servers with unconfigured NICs.

I'd appreciate any ideas. Thx.

[aojea]

How are you doing the trunk?LACP or Trunk?

Are all the vlans tagged in the trunk?

[jsu]

It's a standard static trunk on Hnet vlan. The vlan/trunk isn't tagged. I've attached a sanitized config file. To simplify the situation, I'm only using two ports from the quad port NIC.

From the Switch CLI I can ping the default-gateway. I can't ping it from the trunked/teamed server.

Thx.

[Tijl van der Steeg]

What did you select in NCU? In this screen

http://www.kathmann.com/upload/etherchannel/ios_etherchannel_04.gif