Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Trunking in 5412zl to support Netapp Storage teaming

Fazrul
Occasional Contributor

Trunking in 5412zl to support Netapp Storage teaming

Hi,
We are currently using Procurve 5412zl and Netapp Storage. We are going to configure Netapp storage ethernet interface into trunk mode (2 ethernet interface trunk/team together). According to Netapp, for Cisco switch users, we need to enable "trunking" on the ports to which the Netapp is going to be connected. However, for Procurve switch, we do not see such options. When it comes to configuring ports, we only have options Untagged, Tagged, Forbid and No. I have done trunking/tagging in procurve switches before but that is "switch-to-switch" connection, never done any such thing for servers or storage devices. How do I go about enabling this "trunking mode" in procurve switch? Or is the feature supported and enabled by default on all ports? Thanks.
2 REPLIES
Matt Hobbs
Honored Contributor

Re: Trunking in 5412zl to support Netapp Storage teaming

Should be very straight forward, do the same thing as you would do if connecting two switches together via an aggregated link.

e.g. 5412(config)# trunk a1-a2 trk1 trunk
Fazrul
Occasional Contributor

Re: Trunking in 5412zl to support Netapp Storage teaming

Ok, thanks. I will try it out.

Thanks man.