Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Unreachable Devices in PCM2.0+

Alen Ahja
Frequent Advisor

Unreachable Devices in PCM2.0+

Hi everybody,

i have a phenomenon.
I have updated PCM from 1.6+ to 2.0+ and now some switches were shown as Unreachable but the aren't - because i can ping them and also the server, where PCM is installed, can ping them in the command line.

Can somebody help me why it is?

Thanx for help.

Alen Ahja
2 REPLIES
Mugilvannan
Valued Contributor

Re: Unreachable Devices in PCM2.0+

Hi,
Try to configure again the switches in PCM 2.0+ and let me knw.

Note:
1. ProCurve Manager version 2.0 (PCM 2.0) is not backward compatible with earlier versions. Once you have installed PCM 2.0 on the management server, you cannot revert to a previously installed version.
2. ProCurve Manager cannot be run on the same workstation as HP TopTools.

Thanks,
Mugil
If U need a helping hand, U will find one at the end of your arm
Alen Ahja
Frequent Advisor

Re: Unreachable Devices in PCM2.0+

Hi!

I found my problem: There were wrong settings in the SNMP settings, which the PCM need to communicate. After resetting the SNMP settings manually on the switches it works fine.

Thanx for help.

Alen Ahja