Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

VLAN Routing on 2650

SOLVED
Go to solution
nano2k6
Occasional Contributor

VLAN Routing on 2650

Hi

That is the problem I can't ping the DHCP Server from VLAN 11 but yes from VLAN 10...

The dhcp server is configured with those attribute...(router attribute to be 192.168.11.254 - vlan 11 ip address as default gateway).

This is my ip route to routing device (192.168.10.252 <--> LAN Interface on SonicWall FW):
0.0.0.0/0 192.168.10.252 10 static 1 1

and inside of de router device (SonicWall) is a router to VLAN 11:
ip route 192.168.11.0/24 192.168.10.144

Thanks :)
NaNo2k6
2 REPLIES
Mohieddin Kharnoub
Honored Contributor
Solution

Re: VLAN Routing on 2650

Hi

The DHCP Scope for Vlan11 is correct, and the FW routes are correct, and the config you attached is correct.

But:
- Can you ping vlan10 from vlan11? with this configuration i don't think you can unless you remove the command "primary-vlan 10" because this will not include Vlan10 in the routing table.

After removing this line, you should be able to ping Van10 from vlan11, and the DHCP and the Sonicwall Firewall.

and you still have to check your FW settings, maybe its not allowing the network 192.168.11.0/24.

Good Luck !!!
Science for Everyone
Matt Hobbs
Honored Contributor

Re: VLAN Routing on 2650

primary vlan is fine, it is only management-vlan that will stop a vlan from routing.