VLAN between Cisco 2950 and HP 5412zl

[Micheal Cross]

Hi, I have been trying to connect our Hp 5412zl to an old Cisco 2950 but despite my best efforts I must be missing something. Can someone point me in the right direction?

Port F24 is connected via fibre to gig 0/2

HP 5412zl
GVRP enabled, Port F24, untagged VLAN1, tagged VLAN2

Cisco 2950
Config file attached.

[bolli]

Hello
you have to sign the port0/2 to the VLANs you want. Until now you have only said the port that he is a "tagged" port. In CISCO language it calls trunk port.
Sign the port to the VLANs and it should go.

Regards

[Micheal Cross]

Thank you for the reply but I am not sure I understand what you are suggesting. Port gig 0/2 is set as trunking and the show interfaces trunk command shows it is routing vlans 1 and 2.

Port Mode Encapsulation Status Native vlan
Gi0/2 on 802.1q trunking 1

Port Vlans allowed on trunk
Gi0/2 1-4094

Port Vlans allowed and active in management domain
Gi0/2 1-2

Port Vlans in spanning tree forwarding state and not pruned
Gi0/2 1-2

[Micheal Cross]

Found the problem, it was with the client box settings not properly negotiating the link with switch. Not a problem with the vlans after all.