Switches, Hubs, and Modems
1745875 Members
4267 Online
108723 Solutions
New Discussion

Re: VLAN dot1q with 3 VLANs betweem a CISCO and HP procurve 2524 switch

 
Ron Kinner
Honored Contributor

Re: VLAN dot1q with 3 VLANs betweem a CISCO and HP procurve 2524 switch

When you say "I've connected a device with ip=172.16.3.173 to port 2 and I've connected port 1 to the CISCO port with encapsulation dot1q..and I have no connection to the device connected to port 2.
when I change the address of the same device to 172.16.1.173 and connect it to port 3(VLAN 2) i have a ping to it..This is the problem "

Where are you pinging from? What IP address and VLAN? What Device? Does the Device know about VLAN2? If the pinging source is not on either switch, how is it connected? Is there a router in the way? Does either switch do level 3?

What do
sh vers
and
sh trunk
show on the Cisco?

Ron

lora ganeva_2
New Member

Re: VLAN dot1q with 3 VLANs betweem a CISCO and HP procurve 2524 switch

thank Yoy all for replying..the problem was that a command in the cisco device, which should be enabled by default was not..this command is not visible in the configuration:
"switchport trunk allowed vlan all"