VLAN setup question

[Vlancurve]

Hi all
I'm new to the VLAN networking.
I'd like to accomplish creating 2 VLANs on the switch to connect trunked to the single interface on the SoniceWall 2040 firewall.

What ports on the switch do I need to tag or untag and tag with what ID?

And if any of you have an experience with SonicWall FW, do I need to tag both the X0 and the X0:v2 or just one of them? If just one, which one?


Sonicwall 2040 (supports VLAN)
Port X0 172.16.1.0/24
VLAN ID: 0

Port X0:V2 192.168.1.0/24 (sub-interfance on the same X0 port)
VLAN ID: 2



PROCURVE SWITCH 2650
Single Unplink port to the firewall = Port 48

VLAN ID:0
POrts: 1-23
For the network 172.16.1.0/24


VLAN ID:2
Ports:24-44
For the network 192.168.1.0/24

[Pieter 't Hart · Accepted solution]

you can't use vlan-id "0" (unless on the SonicWall this means "untagged")
so let's say you use vlan 2 and 3.
you can give a vlan a name "vlan0"
but that would be confusing.

vlan 2
name vlan0
exit

>>>
do I need to tag both the X0 and the X0:v2 or just one of them?
<<<

it just must match the config on the procurve switch.

if you use untagged + tagged on the SonicWall, then do the same on the procurve.
(same for tagged/tagged).
I would suggest using both tagged.
By default, the switch allows a maximum of 8 VLANs.

>>>
trunked to the single interface
<<<
procurve port-truking refers to link-agregation/etherchannel configuration (not same as vlan-trunk on cisco)

>>>
so PROCURVE SWITCH 2650
Single Unplink port to the firewall = Port 48

VLAN 2
tagged 48
exit
VLAN 3
tagged 48
exit

[Vlancurve]

Thanks, I'll give it a shot once I get the equipments.
I'll post again if I run into anything.