VLAN with HP Procurve and Cisco 2821

[Andreas Schmidt_2]

Hello.

I have mismatched something, but no success. I have attached the configuration files of all my componentes. Please look at this and feel free to grumble about my inability.

Andreas

[Andreas Schmidt_2]

Could it be a problem of port trunk between HP switch and Cisco router ?

A.

[Mohieddin Kharnoub]

Hi

I checked the configuration, and i have some points:
- You are using a Trunk between the Core switch 2824 and cisco router, this trunk is only one link and it should be at least 2, so i think you are confused by the term TRUNK.
In cisco Trunk is a link carries multiple Vlans and i think that was your target.
All other vendors consider trunk is a Multiple physical lines combined together to form one logical link, for speed and redundancy.

- After you remove the trunk from Port24 on core switch, make it untagged to Vlan1, and tagged to all other Vlans.

And that will be enough for you to start.
Again, this example is very good for better understanding:
http://www.cisco.com/en/US/tech/tk389/tk390/technologies_configuration_example09
186a00800949fd.shtml

Good Luck !!!