HPE Community
Switches, Hubs, and Modems
1753944 Members
8664 Online
108811 Solutions
New Discussion юеВ

Re: VLANs on ProCurve 2848

 
Manfred Arndt
Valued Contributor

тАО10-31-2005 11:24 AM

тАО10-31-2005 11:24 AM

Re: VLANs on ProCurve 2848

native is untagged
0 Kudos
john_1114
Advisor

тАО11-01-2005 05:10 AM

тАО11-01-2005 05:10 AM

Re: VLANs on ProCurve 2848

Using the Cisco PIX 506e, you are only allowed 2 VLANs, so one may need to be native (untagged) as it goes through the trunk to the switch.

As I understand it though, that should be okay, as
the LAN VLAN would be untagged going into port 5 on the switch, and the DMZ VLAN would be tagged going into port 5 on the switch.

Would this be okay?
Thanks in advance
J
0 Kudos
Manfred Arndt
Valued Contributor

тАО11-01-2005 06:24 AM

тАО11-01-2005 06:24 AM

Re: VLANs on ProCurve 2848

John,

Not sure if a PIX requires an untagged VLAN -- but if it does, then using untagged for LAN VLAN and tagged for DMZ VLAN on port 5 would be fine.

Cheers
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.